Configuring Message Routing

Specify Remote Hosts and IP Addresses

The Stack tab options on a TCP/IP X.400 connector allow you to specify transport address information about the remote X.400 system to which you want to connect. Information displayed on the Stack tab is based on the X.400 transport stack selected for the X.400 connector.

Important   Information on the X.400 connector Stack tab must match the transport configuration on the remote X.400 system for the connection to work.

To specify remote hosts and IP addresses:

  1. Start System Manager
    on the Start menu, point to Programs, point to Microsoft Exchange, and then click System Manager.
  2. Navigate to the Connectors node.

    System Manager

    1. Administrative Groups
    2. Administrative Group
    3. Routing Groups
    4. Routing Group
    5. Connectors
    6. Connector
  3. Right-click a TCP/IP X.400 connector, and then click Properties.
  4. Click the Stack tab.
  5. Select Remote Host Name or IP Address.
  6. In Address, type the host name or IP address.