Applies to: Exchange Server 2013, Exchange Online
Topic Last Modified: 2012-11-05
After you delete a Unified Messaging (UM) hunt group, the UM IP gateway associated with the UM hunt group will no longer service or answer incoming calls. If deleting the UM hunt group leaves the UM IP gateway without any remaining configured hunt groups, the UM IP gateway can't handle or process UM calls.
For additional tasks related to UM hunt groups, see UM Hunt Group Procedures.
|If you want to change the UM hunt group settings, you must delete the hunt group and then create another hunt group that has the appropriate settings.|
What do you need to know before you begin?
- Estimated time to complete: Less than 1 minute.
- You need to be assigned permissions before you can perform this
procedure or procedures. To see what permissions you need, see the
"UM hunt groups" entry in the Unified Messaging
- Before you perform these procedures, confirm that a UM dial
plan has been created. For detailed steps, see Create a UM Dial
- Before you perform these procedures, confirm that a UM IP
gateway has been created. For detailed steps, see Create a UM IP
- Before you perform these procedures, confirm that a UM hunt
group has been created. For detailed steps, see Create a UM Hunt
- For information about keyboard shortcuts that may apply to the
procedures in this topic, see Keyboard Shortcuts in
the Exchange Admin Center.
What do you want to do?
Use the EAC to delete a UM hunt group
- In the EAC, navigate to Unified Messaging > UM
dial plans. In the list view, click the UM dial plan you want
to change, and on the toolbar, click Edit .
- On the UM Dial Plan page, under UM Hunt Groups,
select the hunt group you want to delete, and on the toolbar, click
- On the Warning page, click Yes.
Use the Shell to delete a UM hunt group
This example deletes a UM hunt group named
Remove-UMHuntGroup -identity MyUMHuntGroup