Applies to: Exchange Server 2013

Topic Last Modified: 2012-07-09

Use the Resume-MailboxImportRequest cmdlet to resume an import request that was suspended or failed.

For information about the parameter sets in the Syntax section below, see Syntax.

Syntax

Resume-MailboxImportRequest -Identity <MailboxImportRequestIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

Examples

EXAMPLE 1

This example resumes the second import request for Kweku's mailbox kweku\MailboxImport1

Copy Code
Resume-MailboxImportRequest -Identity kweku\MailboxImport1

EXAMPLE 2

This example resumes all failed import requests.

Copy Code
Get-MailboxImportRequest -Status Failed | Resume-MailboxImportRequest

Detailed Description

This cmdlet can be pipelined with the Get-MailboxImportRequest cmdlet.

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Import Export" entry in the Recipients Permissions topic.

Parameters

Parameter Required Type Description

Identity

Required

Microsoft.Exchange.Management.RecipientTasks.MailboxImportRequestIdParameter

The Identity parameter specifies the identity of the import request. By default, import requests are named <alias>\MailboxImportX (where X = 0–9). If you created the request using the Name parameter, use the following syntax: <alias>\<name>.

Confirm

Optional

System.Management.Automation.SwitchParameter

The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.

DomainController

Optional

Microsoft.Exchange.Data.Fqdn

The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

WhatIf

Optional

System.Management.Automation.SwitchParameter

The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

Input Types

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

Return Types

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.