Applies to: Exchange Server 2013
Topic Last Modified: 2012-06-29
Use the Enable-UMIPGateway cmdlet to enable a Unified Messaging (UM) IP gateway.
For information about the parameter sets in the Syntax section below, see Syntax.
Syntax
Enable-UMIPGateway -Identity
<UMIPGatewayIdParameter> [-Confirm [<SwitchParameter>]]
[-DomainController <Fqdn>] [-WhatIf
[<SwitchParameter>]]
|
Examples
EXAMPLE 1
This example enables the UM IP gateway MyUMIPGateway.
 Copy Code |
|
|---|---|
Enable-UMIPGateway -Identity MyUMIPGateway |
|
Detailed Description
The status variable for a UM IP gateway can be used to enable or disable call answering destined for the IP gateway. The Enable-UMIPGateway cmdlet enables a UM IP gateway in Active Directory by modifying its status variable.
After this task is completed, the UM IP gateway answers incoming calls and makes outgoing calls through the IP gateway or IP Private Branch eXchange (PBX).
You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "UM IP gateways" entry in the Unified Messaging Permissions topic.
Parameters
| Parameter | Required | Type | Description |
|---|---|---|---|
|
Identity |
Required |
Microsoft.Exchange.Configuration.Tasks.UMIPGatewayIdParameter |
The Identity parameter specifies the identifier for the UM IP gateway being enabled. This parameter is the directory object ID for the UM IP gateway. |
|
Confirm |
Optional |
System.Management.Automation.SwitchParameter |
The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch. |
|
DomainController |
Optional |
Microsoft.Exchange.Data.Fqdn |
The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory. |
|
WhatIf |
Optional |
System.Management.Automation.SwitchParameter |
The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch. |
Input Types
To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.
Return Types
To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.