Applies to: Exchange Server 2013
Topic Last Modified: 2013-01-11
Use the Remove-MailboxSearch cmdlet to remove a mailbox search.
For information about the parameter sets in the Syntax section below, see Syntax.
Syntax
Remove-MailboxSearch -Identity
<EwsStoreObjectIdParameter> [-Confirm
[<SwitchParameter>]] [-DomainController <Fqdn>]
[-WhatIf [<SwitchParameter>]]
|
Examples
EXAMPLE 1
This example removes the mailbox search Project Contoso.
 Copy Code |
|
|---|---|
Remove-MailboxSearch -Identity "Project Contoso" |
|
Detailed Description
In Microsoft Exchange Server 2013, mailbox searches are used for In-Place eDiscovery and In-Place Hold. You can't remove an In-Place Hold without first disabling the hold.
You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "In-Place eDiscovery" entry in the Messaging Policy and Compliance Permissions topic.
Parameters
| Parameter | Required | Type | Description |
|---|---|---|---|
|
Identity |
Required |
Microsoft.Exchange.Configuration.Tasks.EwsStoreObjectIdParameter |
The Identity parameter specifies the name of the mailbox search. |
|
Confirm |
Optional |
System.Management.Automation.SwitchParameter |
The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch. |
|
DomainController |
Optional |
Microsoft.Exchange.Data.Fqdn |
The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory. |
|
WhatIf |
Optional |
System.Management.Automation.SwitchParameter |
The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch. |
Input Types
To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.
Return Types
To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.