Applies to: Exchange Server 2013, Exchange Online
Topic Last Modified: 2013-01-11
Use the Enable-JournalRule cmdlet to enable an existing journal rule on a Mailbox server.
For information about the parameter sets in the Syntax section below, see Syntax.
Syntax
Enable-Journalrule -Identity <RuleIdParameter>
[-Confirm [<SwitchParameter>]] [-DomainController
<Fqdn>] [-LawfulInterception <SwitchParameter>]
[-WhatIf [<SwitchParameter>]]
|
Examples
EXAMPLE 1
This example enables the existing journal rule Brokerage Communications.
 Copy Code |
|
|---|---|
Enable-JournalRule "Brokerage Communications" |
|
Detailed Description
You can enable or disable specific journal rules in your organization at any time using the Enable-JournalRule and Disable-JournalRule cmdlets. To learn more about journaling in Microsoft Exchange Server 2013, see Journaling.
You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Journaling" entry in the Messaging Policy and Compliance Permissions topic.
Parameters
| Parameter | Required | Type | Description |
|---|---|---|---|
|
Identity |
Required |
Microsoft.Exchange.MessagingPolicies.Rules.Tasks.RuleIdParameter |
The Identity parameter specifies the journal rule you want to enable. Enter either the name or GUID of the journal rule. You can omit this parameter label. |
|
Confirm |
Optional |
System.Management.Automation.SwitchParameter |
The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch. |
|
DomainController |
Optional |
Microsoft.Exchange.Data.Fqdn |
The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory. |
|
LawfulInterception |
Optional |
System.Management.Automation.SwitchParameter |
This parameter is reserved for internal Microsoft use. |
|
WhatIf |
Optional |
System.Management.Automation.SwitchParameter |
The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch. |
Input Types
To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.
Return Types
To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.