Applies to: Exchange Server 2013
Topic Last Modified: 2013-01-11
Use the Remove-ResubmitRequest cmdlet to remove requests to replay redundant copies of messages from Safety Net after a mailbox database recovery.
For information about the parameter sets in the Syntax section below, see Syntax.
Syntax
Remove-ResubmitRequest -Identity
<ResubmitRequestIdentityParameter> [-Confirm
[<SwitchParameter>]] [-Server <ServerIdParameter>]
[-WhatIf [<SwitchParameter>]]
|
Examples
Example 1
This example removes the resubmit request with the identity 5.
 Copy Code |
|
|---|---|
Remove-ResubmitRequest 5 |
|
Example 2
This example removes all resubmit requests.
| Copy Code |
|
|---|---|
Get-ResubmitRequest | Remove-ResubmitRequest |
|
Detailed Description
You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Queues" entry in the Mail Flow Permissions topic.
Parameters
| Parameter | Required | Type | Description |
|---|---|---|---|
|
Identity |
Required |
Microsoft.Exchange.Configuration.Tasks.ResubmitRequestIdentityParameter |
The Identity parameter specifies the resubmit request you want to remove. Each resubmit request is identified by an incremented integer value. |
|
Confirm |
Optional |
System.Management.Automation.SwitchParameter |
The Confirm switch can be used to suppress the
confirmation prompt that appears by default when this cmdlet is
run. To suppress the confirmation prompt, use the syntax
|
|
Server |
Optional |
Microsoft.Exchange.Configuration.Tasks.ServerIdParameter |
The Server parameter specifies the Exchange server on which you want to run this command. You can use any value that uniquely identifies the server. For example:
If you don't use the Server parameter, the command is run on the local server. |
|
WhatIf |
Optional |
System.Management.Automation.SwitchParameter |
The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch. |
Input Types
To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.
Return Types
To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.