Applies to: Exchange Server 2013
Topic Last Modified: 2013-01-11
Use the Remove-UMMailboxPolicy cmdlet to delete a Unified Messaging (UM) mailbox policy.
For information about the parameter sets in the Syntax section below, see Syntax.
Syntax
Remove-UMMailboxPolicy -Identity
<MailboxPolicyIdParameter> [-Confirm
[<SwitchParameter>]] [-DomainController <Fqdn>]
[-WhatIf [<SwitchParameter>]]
|
Examples
EXAMPLE 1
This example deletes the UM mailbox policy MyUMMailboxPolicy.
 Copy Code |
|
|---|---|
Remove-UMMailboxPolicy -Identity MyUMMailboxPolicy |
|
Detailed Description
The Remove-UMMailboxPolicy cmdlet deletes or removes a UM mailbox policy. If the UM mailbox policy is deleted from Active Directory, the UM mailbox policy can't be used when configuring UM-enabled users. The UM mailbox policy can't be deleted if the UM mailbox policy is referenced by any UM-enabled mailboxes.
After this task is completed, the UM mailbox policy is removed from Active Directory.
You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "UM mailbox policies" entry in the Unified Messaging Permissions topic.
Parameters
| Parameter | Required | Type | Description |
|---|---|---|---|
|
Identity |
Required |
Microsoft.Exchange.Configuration.Tasks.MailboxPolicyIdParameter |
The Identity parameter specifies the identifier for the UM mailbox policy being deleted. This parameter is the directory object ID for the UM mailbox policy. |
|
Confirm |
Optional |
System.Management.Automation.SwitchParameter |
The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch. |
|
DomainController |
Optional |
Microsoft.Exchange.Data.Fqdn |
The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory. |
|
WhatIf |
Optional |
System.Management.Automation.SwitchParameter |
The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch. |
Input Types
To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.
Return Types
To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.