Applies to: Exchange Server 2013
Topic Last Modified: 2012-06-07
Use the Remove-DlpPolicyTemplate cmdlet to remove a data loss prevention (DLP) policy template from your organization.
For information about the parameter sets in the Syntax section below, see Syntax.
Syntax
Remove-DlpPolicyTemplate [-Identity
<DlpPolicyIdParameter>] [-Confirm [<SwitchParameter>]]
[-DomainController <Fqdn>] [-WhatIf
[<SwitchParameter>]]
|
Examples
Example 1
This example removes the DLP policy template named External DLP Policy Template.
 Copy Code |
|
|---|---|
Remove-DlpPolicyTemplate "External DLP Policy Template" |
|
Detailed Description
You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Data loss prevention (DLP)" entry in the Messaging Policy and Compliance Permissions topic.
Parameters
| Parameter | Required | Type | Description |
|---|---|---|---|
|
Confirm |
Optional |
System.Management.Automation.SwitchParameter |
The Confirm switch can be used to suppress the
confirmation prompt that appears by default when this cmdlet is
run. To suppress the confirmation prompt, use the syntax
|
|
DomainController |
Optional |
Microsoft.Exchange.Data.Fqdn |
The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory. |
|
Identity |
Optional |
Microsoft.Exchange.MessagingPolicies.CompliancePrograms.Tasks.DlpPolicyIdParameter |
The Identity parameter specifies the DLP policy template you want to remove. You can use any value that uniquely identifies the DLP policy template. For example, you can specify the name, GUID, or distinguished name (DN) of the DLP policy template. |
|
WhatIf |
Optional |
System.Management.Automation.SwitchParameter |
The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch. |
Input Types
To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.
Return Types
To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.