Applies to: Exchange Server 2007 SP3, Exchange Server
2007 SP2, Exchange Server 2007 SP1, Exchange Server 2007
Topic Last Modified: 2007-08-22
This topic explains how to use the Exchange Management Console or the Exchange Management Shell to configure Internet Message Access Protocol version 4rev1 (IMAP4) to use Transport Layer Security (TLS) or Secure Sockets Layer (SSL). In the original release (RTM) version of Exchange 2007, you could only configure IMAP4 to use TLS or SSL by using the Exchange Management Shell. In Exchange 2007 Service Pack 1 (SP1), you can also configure IMAP4 to use TLS or SSL by using the Exchange Management Console. Steps for doing this are included in this topic.
Note: |
---|
After you have configured IMAP4 to use TLS or SSL, you must restart the IMAP4 service. For more information about how to restart the IMAP4 service, see How to Start and Stop the IMAP4 Service. |
Before You Begin
To perform the following procedures on a computer that has the IMAP4 service enabled, the account you use must be delegated the Exchange Server Administrators role and membership in the local Administrators group for the target server.
For more information about permissions, delegating roles, and the rights that are required to administer Microsoft Exchange Server 2007, see Permission Considerations.
Procedure
Exchange 2007 SP1
To use the Exchange Management Console to configure IMAP4 to use TLS or SSL
-
In the console tree, expand Server Configuration, and then click Client Access.
-
In the work pane, click the POP3 and IMAP4 tab.
-
In the work pane, select IMAP4 and then, in the action pane, click Properties.
-
On the IMAP4 Properties page, click the Authentication tab.
-
In the box under X.509 certificate name, enter the name of the certificate.
-
Click Apply, and then click OK to save your changes.
To use the Exchange Management Shell to configure IMAP4 to use TLS or SSL
-
Run the following command:
Copy Code Set-ImapSettings -server Server01 -X509CertificateName CertificateName01
For more information about syntax and parameters, see Set-IMAPSettings.
Exchange 2007 RTM
To use the Exchange Management Shell to configure IMAP4 to use TLS or SSL
-
Run the following command:
Copy Code Set-ImapSettings -server Server01 -X509CertificateName CertificateName01
For more information about syntax and parameters, see Set-IMAPSettings (RTM).
For More Information
For more information about how to set up TLS or SSL on the computer that is running Exchange 2007, see Managing Client Access Security.
For more information about how to manage the IMAP4 protocol, see Managing POP3 and IMAP4.