Applies to: Exchange Server 2007
Topic Last Modified: 2007-07-12

Use the General tab to configure settings for the UM IP gateway. For example, you can configure the IP address that points to an IP gateway or Private Branch eXchange (PBX) that is enabled for Session Initiation Protocol (SIP) on your network. You can also change the display name of the UM IP gateway that was configured when the UM IP gateway was created.

Status

• This display-only field shows the status of the UM IP gateway.
  
  

Modified

• This display-only field shows the date that the UM IP gateway was last modified.
  
  

Address

• Use this field to specify the IP address that is configured on the IP gateway or SIP-enabled IP PBX. This IP address is configured when the UM IP gateway is created.
  
  
• You can use an IP address or a Fully Qualified Domain Name (FQDN) in this field. Alphabetical and numeric characters are accepted in this text box. For legacy PBXs, a numeric value is used for an IP address.
  
  

Allow outgoing calls through this UM IP gateway

• Select this check box to allow the UM IP gateway to accept and process outgoing calls. This setting does not affect call transfers or incoming calls from an IP gateway.
  
  
• By default, when the UM IP gateway is created, this setting is enabled. If you disable this setting, users that are associated with the dial plan will be unable to make outgoing calls through the IP gateway that is defined in the Address field.
  
  

For More Information

To ensure that you are reading the most up-to-date information and to find additional Exchange Server 2007 documentation, visit the Exchange Server TechCenter.

---

© 2008 Microsoft Corporation. All rights reserved. Legal Information