Applies to: Exchange Server 2007
Topic Last Modified: 2007-06-14
Use the Source Server page of the New SMTP Send Connector wizard to specify the Transport servers that can use this Send connector. The list of source servers can contain all Hub Transport servers or all subscribed Edge Transport servers, but not a mix of both.
Only those Hub Transport servers in the list will use this Send connector to determine the best route for mail delivery. If the source server list contains a set of subscribed Edge Transport servers, the Microsoft Exchange EdgeSync service will propagate this Send connector configuration to the Edge Transport servers in the list.
- Add
-
To add a Hub Transport server or a subscribed Edge Transport server, click Add.
- Remove
-
To remove a server from the list, select the server, and then click
.
Note:Removing a subscribed Edge Transport server from the list doesn't remove the Send connector from the Edge Transport server itself. It just stops the Microsoft Exchange EdgeSync service from propagating this Send connector configuration to that Edge Transport server.
For More Information
For more information about Send connectors and EdgeSync, see the following topics:
- Managing
Connectors
- Send
Connectors
- Configuring
Edge Transport Server Connectors
- Subscribing
the Edge Transport Server to the Exchange Organization
- How to
Create a New Send Connector
- How to
Modify the Configuration of a Send Connector
- How to
Remove a Send Connector
- How to View
the Configuration of a Send Connector
- Send
Connector Cmdlets (RTM)
- EdgeSync
Cmdlets (RTM)