Applies to: Exchange Server 2007 SP3, Exchange Server 2007 SP2, Exchange Server 2007 SP1
Topic Last Modified: 2007-07-23

Use the Local Network Settings page of the New SMTP Receive Connector wizard to specify the local IP addresses for which the Receive connector will receive e-mail messages. The Local network settings page appears only if you selected a usage type of Custom, Partner, or Internet on the Introduction page.

Add

To add one or more IP addresses, click Add. You can use all available IP addresses or specify a single IP address.

Note:
You must specify a local IP address that is valid for the Hub Transport server or Edge Transport server on which the Receive connector is located. If you specify an invalid local IP address, the Microsoft Exchange Transport service may fail to start when the service is restarted. To specify all IP addresses that are configured on all network adapters, select Use all IP addresses available on this server.
Edit

To change an existing IP address, select the IP address, and then click Edit.

Remove

To remove an IP address from the list of local IP addresses, select the IP address, and then click Remove icon.

Specify the (FQDN) this connector will provide in response to HELO or EHLO

This field specifies the fully qualified domain name (FQDN) that is used as the destination server for connected messaging servers that use the Receive connector to send incoming messages. The value of this field is displayed to connected messaging servers whenever a destination server name is required, as in the following examples:

  • In the default SMTP banner of the Receive connector

  • In the EHLO/HELO response of the Receive connector

  • In the most recent Received: header field in the incoming message when the message enters the Hub Transport server or Edge Transport server

  • During Transport Layer Security (TLS) authentication

For More Information