Topic Last Modified: 2010-11-08
To successfully complete this procedure you should be logged on as a user who is a member of the RTCUniversalServerAdmins group.
In a site, Front End Servers, Standard Edition servers, and Directors can use a Kerberos authentication account for purposes of authenticating requests to the Web Services service. This procedure locates each server running Web Services in a site that has been assigned a Kerberos account and updates the Internet Information Services (IIS) configuration settings to use the Kerberos account. For details, see Set a Kerberos Authentication Account Password on a Server.
To set and configure a Kerberos authentication account password
Log on to a source computer (such as fe01.contoso.com) as a member of RTCUniversalServerAdmins group.
Start the Lync Server Management Shell: Click Start, click All Programs, click Microsoft Lync Server 2013, and then click Lync Server Management Shell.
From the Lync Server Management Shell command line, run the following two commands:
Set-CsKerberosAccountPassword -FromComputer SourceComputer -ToComputer DestinationComputer
Set-CsKerberosAccountPassword -FromComputer fe01.contoso.com -ToComputer dir01.contoso.com
Important: The name of the source computer and destination computer must be a fully qualified domain (FQDN) name of the server. You cannot use the pool FQDN unless the pool name is the same as the name of the computer that you are using as a source computer or destination computer. Important: After making any changes to Kerberos authentication, such as adding an account or removing an account, you must run Enable-CsTopology from the Lync Server Management Shell command prompt.