[This is pre-release documentation and subject to change in future releases. This topic's current status is: Milestone-Ready]

Topic Last Modified: 2010-07-19

After you install the Local Configuration Store, install the Communications Server Components, and configure certificates on a Director, you must start the Communications Server services on the server. You can use the following procedure to start services on each Director in your deployment.

To start services on a Director

  1. In the Communications Server 2010 (Beta Refresh) – Deployment Wizard, on the Communications Server 2010 (Beta Refresh) page, click the Run button next to Step 4: Start Services.

  2. On the Start Services page, click Next to start the Communications Server services on the server.

  3. On the Executing Commands page, after all services have started successfully, click Finish.