[This is pre-release documentation and subject to change in future releases. This topic's current status is: Milestone-Ready]

Topic Last Modified: 2010-07-19

Use the following steps to install the Communications Server 2010 Components on a Director.

To install Communications Server components on a Director

  1. In the Communications Server 2010 (Beta Refresh) – Deployment Wizard, on the Communications Server 2010 (Beta Refresh) page, next to Step 2: Setup or Remove Communications Server Components, click Run.

  2. On the Setup Communications Server Components page, click Next to set up components as defined in the published topology.

  3. When Communications Server components setup has completed, click Finish.