ConferenceDateTime

Datetime

primary

Referenced from the MediaLine Table.

SessionSeq

Int

primary

Referenced from the MediaLine Table.

MediaLineLabel

tinyint

primary

Referenced from the MediaLine Table.

FromCaller

bit

primary

0: Callee’s data

1: Caller’s data

NetworkSendQualityEventRatio

Decimal(5,2)

Percentage of session the NetworkSendQuality event was fired for ‘Bad’ state.

Network quality in terms of jitter and/or packet loss is severe and impacting the quality of audio being sent.

NetworkReceiveQualityEventRatio

Decimal(5,2)

Percentage of session the ReceiveSendQuality event was fired for ‘Bad’ state.

Network quality in terms of jitter and/or packet loss is severe and impacting the quality of audio being received.

NetworkDelayEventRatio

Decimal(5,2)

Percentage of session the Delay event was fired for ‘Bad’ state. Network latency is severe and impacting the experience by preventing interactive communication

NetworkBandwidthLowEventRatio

Decimal(5,2)

Percentage of session the LowBandwidth event was fired for ‘Bad’ state. The available bandwidth is insufficient for an acceptable voice experience.

CPUInsufficientEventRatio

Decimal(5,2)

Percentage of session the Insufficient CPU event was fired for ‘Bad’ state. There are insufficient CPU cycles for processing with the current modalities and applications in use. This causes distortions with the audio channel.

DeviceHalfDuplexAECEventRatio

Decimal(5,2)

Percentage of session the DeviceHalfDuplexAEC event was fired for ‘Bad’ state. In order to prevent echo, the system has enter half duplex

DeviceRenderNotFunctioningEventRatio

Decimal(5,2)

Percentage of session the DeviceRenderNotFunctioning event was fired for ‘Bad’ state. The render device currently being used for the session is not functioning correctly. This can cause one-way audio issues.

DeviceCaptureNotFunctioningEventRatio

Decimal(5,2)

Percentage of session the DeviceCaptureNotFunctioning event was fired for ‘Bad’ state. The capture device currently being used for the session is not functioning correctly. This can cause one-way audio issues.

DeviceGlitchesEventRatio

Decimal(5,2)

Percentage of session the DeviceGlitches event was fired for ‘Bad’ state. There are severe glitches in the rendering of audio which is causing distortions. These glitches can be caused by driver issues, DPC storm (drivers), high CPU usage

DeviceLowSNREventRatio

Decimal(5,2)

Percentage of session the DeviceLowSNR event was fired for ‘Bad’ state. The capture quality is very poor, either very noisy or user is talking too far away from the microphone. This will cause distortions.

DeviceLowSpeechLevelEventRatio

Decimal(5,2)

Percentage of session the DeviceLowSpeechLevel event was fired for ‘Bad’ state. User‘s speech level is too low and the system cannot increase it any further. This can either cause distortions or perceived as one-way audio.

DeviceClippingEventRatio

Decimal(5,2)

Percentage of session the DeviceClipping event was fired for ‘Bad’ state.

When near end speech clips the microphone, far end hears distortion due to clipping. It is important to avoid near end microphone clipping.

DeviceEchoEventRatio

Decimal(5,2)

Percentage of session the DeviceEchoEvent event was fired for ‘Bad’ state. Device or setup is causing echo beyond the ability of the system to compensate.

DeviceNearEndToEchoRatioEventRatio

Decimal(5,2)

Percentage of session the DeviceNearEndToEchoRatio event was fired for ‘Bad’ state. The user’s speech is too low compared to the echo being captured which impacts the users experience because it limits how easy it is to interrupt a user. Reduce speaker volume, move the microphone closer to talker.

DeviceMultipleEndpointsEventCount

int

Foreign

Number of times during session the DeviceMultipleEndpoints event was fired for ‘Bad’ state. Multiple audio endpoints in the same session detected and the system has compensated by reducing render volume.

DeviceHowlingEventCount

int

Number of times during session the DeviceHowlingEvent event was fired for ‘Bad’ state. Audio feedback loop detected (caused by multiple endpoints sharing audio path).