New-CsSipProxyTCP -IPAddress <String>

Parameters

When you send a SIP (Session Initiation Protocol) message to someone that message might need to traverse multiple subnets and networks before it is delivered; the path traveled by the message is often referred to as a route. In networking, there are two types of routes: dynamic and static. With dynamic routing, servers use algorithms to determine the next location (the next hop) where a message should be forwarded. With static routing, message paths are predetermined by system administrators. When a message is received by a server, the server checks the message address and then forwards the message to the next hop server that has been preconfigured by an administrator. If configured correctly, static routes help ensure timely, and accurate, delivery of messages, and with minimal overheard placed on servers. The downside to static routes? Messages are not dynamically rerouted in the event of a network failure.

Microsoft Communications Server 2010 enables you to set up static routes for proxy servers. These routes are composed of two primary pieces: proxy configuration settings (created using New-CsProxyConfiguration), and SIP proxy routes. In turn, SIP proxy routes have a number of properties; for example, each route must have a Transport, a property that defines the network protocol used for transmitting messages along the route.

Microsoft Communications Server allows you to specify either TCP (Transmission Control Protocol) or TLS (Transport Layer Security) as your transport protocol. If you decide to use TCP as your protocol, you must first create a TCP object using the New-CsSipProxyTCP cmdlet. You can then use that object to specify the protocol for the Transport object created by New-CsSipProxyTransport.

You do not need to use New-CsSipProxyTCP if you use New-CsStaticRoute to create your static route.

New-CsSipProxyTCP creates new instances of the Microsoft.Rtc.Management.WriteableConfig.Settings.SipProxy.TCP object.

-------------------------- Example 1 ------------------------

	Copy Code
$tcp = New-CsSipProxyTCP -IPAddress 192.168.1.100 $transport = New-CsSipProxyTransport -TransportChoice $tcp -Port 7500

The commands shown in Example 1 create a new SIP proxy transport object that uses TCP as its transport. To do this, the first command in the example uses New-CsSipProxyTCP to create a new SipProxy.TCP object that points to the next hop server with the IP address 192.168.1.100; this TCP object is stored in a variable named $tcp.

After the SipProxy.TCP object has been created, the New-CsSipProxyTransport cmdlet creates a TCP transport object.