You can set the days and times that a Connection Agreement polls
the bridgehead servers for directory changes to replicate. The
first time replication occurs, the entire directory is replicated
by default. By default, polling takes place approximately every
five seconds during scheduled times that you specify. Polling
checks for changes in each directory defined in the Connection
Agreement.
To set up a replication schedule:
If you have not yet opened the Connection Agreement in ADC,
do the following:
On the Start menu, point to Programs, point to
Administrative Tools, and then click Active Directory
Connector.
In the details pane, double-click the Connection Agreement for
which you want to schedule replication.
On the Schedule tab, click Never, Always,
or Selected times.
Click Never to disable the Connection Agreement.
Click Always to enable automatic replication whenever
the source directory changes.
Click Selected times to configure replication times.
Click the boxes in the schedule that correspond to the time(s) and
date(s) you want to replicate the directories.
For example, to schedule replication for every Wednesday at 6:00
P.M., click Selected times, and then click the schedule grid
in the box that corresponds to 6:00 P.M. vertically and Wednesday
horizontally.
Under Detail view, click 1 hour to display the
schedule in 1-hour intervals, or 15 Minute to display the
schedule in 15-minute intervals.
Note After initial
replication, ADC only replicates changes that occur between
directories. To replicate the entire directory at a later time,
click Replicate the entire directory the next time the agreement
is run.