Applies to: Exchange Server 2010 SP3, Exchange Server 2010 SP2

Topic Last Modified: 2012-11-19

Use the Remove-UMDialplan cmdlet to delete an existing Unified Messaging (UM) dial plan.

Syntax

Remove-UMDialPlan -Identity <UMDialPlanIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

Detailed Description

The Remove-UMDialplan cmdlet deletes an existing UM dial plan from Active Directory. You need to make sure the UM dial plan isn't being used by other UM objects such as UM mailbox policies or UM IP gateways. When you delete an existing UM dial plan, the cmdlet verifies that the specified UM dial plan isn't referenced by a Unified Messaging server, UM IP gateway, or UM mailbox policies. The only benefit gained from deleting an obsolete UM dial plan is to reuse the name or perform general Active Directory housekeeping.

After this task is completed, the UM dial plan is removed from Active Directory.

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "UM dial plans" entry in the Unified Messaging Permissions topic.

Parameters

Parameter Required Type Description

Identity

Required

Microsoft.Exchange.Configuration.Tasks.UMDialPlanIdParameter

The Identity parameter specifies the identifier for the UM dial plan being deleted. This is the directory object ID for the UM dial plan.

Confirm

Optional

System.Management.Automation.SwitchParameter

The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.

DomainController

Optional

Microsoft.Exchange.Data.Fqdn

The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

WhatIf

Optional

System.Management.Automation.SwitchParameter

The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

Input Types

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

Return Types

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

Examples

EXAMPLE 1

This example deletes an existing UM dial plan named MyUMDialPlan.

Copy Code
Remove-UMDialplan -Identity MyUMDialPlan