Topic Last Modified: 2012-09-08

After you install the Local Configuration Store, install the Lync Server Components, and configure certificates on a Director, you must start the Lync Server services on the server. You can use the following procedure to start services on each Director in your deployment.

To start services on a Director

  1. In the Lync Server Deployment Wizard, on the Lync Server 2013 page, click the Run button next to Step 4: Start Services.

  2. On the Start Services page, click Next to start the Lync Server services on the server.

  3. On the Executing Commands page, after all services have started successfully, click Finish.

  4. Below Step 4: Start Services, click Services Status (Optional).

  5. In the Services Microsoft Management Console (MMC) on the server, verify that all of the Lync Server 2013 services are running.